Pepe Godzilla

See other comments.

I’d like to add that 3U spacebars are available with 2U and 3U stabilizers. Make sure you have the correct wire size.

I built it in the german layout i’m used to because i went all in on Art Nouveau (hope i spelled that right). Including the novelty, this is base- and 4 childkits 🫥

It’s german qwertz.

Afaik Drop sets are exclusives. You may have a good chance finding those 2nd hand on mechmarket though. Maybe even for less than 100$.

that really is a nice typewriter. I wonder if that spacebar integration can be done on mx as well, because it’s looking really good.

I just started soldering. It’s not too difficult and super useful. Also adds a lot of options that are usually cheaper than hotswap.

A pinecil is 25$. add another 25 for solder, flux, a pump and copper desoldering braid and you’re set up.

I found hotswap is increasingly difficult to get once you’re looking for non-massmarket stuff outside of 60 or 65 keebs with ANSI Layout.

It’s just faster to solder than to search for non-standard hotswap.

And with millmax, you can make any solderboard hotswap if you fancy.

I think the problem might be sound, because the spacebar (and pcb) would be right on top of solid material and the sound can escape to the front. I guess it’ll sound very flat and no one wants to spend 300 bucks on a bad sounding spacebar.

PBT will also shine at some point. Whether it’s sooner or later depends on how you type and how greasy or sweaty your fingers are. PBT can’t do magic, it’s just a, usually softer, plastic.

If you’re looking for cheap caps, try aliexpress or taobao.

I’d love one, but my colleagues…

By design, mechs are quite a bit taller, because the switches are taller.

Unless you’re a “floating” typist, I would recommend a palmrest.