daf
If you want it free, you should selfhosted it
You would also need a computer with your 3d printer as you just don’t feed printer with files from internet. (Actually, they are a few case where you can but it is very limited). As for your question: To save money, you need to earn money…
Can’t talk for the price but you won’t find an other company that match as much your requirements, only issue with prusa mini is the small print area but depending what you want to do, it can be enough.
Do you have on of those plastic extruder? If so, check for a crack (dismantle to check everywhere).
Could also be wrong estep (take Bowden off, cut filament after extruder, extrude 10cm and mesure to see if accurate)
Or maybe a partial clog.
Also check your flow settings in slicer.
Chances are you are squishing too much first layer, so adjust that first. Then print over residue with slow speed and 5-10° hotter than usual settings. Residue should come off with print.
They are not only here but at Reddit too and elsewhere. And if we start like this, why not banning American (attackers) because they promote gun, let’s ban English because of promoting their food. let’s ban…, let’s ban…
I guess you understood my point, you can’t ban people because you disagree and even if what they are saying is bullshit/stupid/dangerous…You can only ban them if they don’t respect rules.
(To Americans and English people, I used stereotypes so I hope you don’t take it personally. It is just for the exemple, love you guys)
archive.org is one. But keep in mind that your address will still be seen whatever torrent site you use unless you are hiding behind vpn.
Got one of this for about 2 years and it is working well. Did you try to adjust spring tension? Also, 20$ is too expensive for those. They cost about 10$
You need to divide by 8, so your max should be 6.25.
Speed test are megabits, files are megabytes