Still needs some design corrections because I just didn’t know how to properly do 3D print and industrial design but it works!
You are viewing a single thread.
View all comments 3 points
*
Amazingly cool! Thanks for sharing!
Heat pipes and fans for cooling? Does the exhaust go out of the wrist area?
1 point
*
So that’s a problem at the moment. I am using Orange pi 5 plus which is an arm processor and it doesn’t get hot by default, plus there’s a fan and heat sink on it, so I didn’t put any exhaust holes for aesthetics, but now it turns on the fan every a few minutes for a minute because it gets too hot in there plus the ssd nvme is generating a lot of heat. it’s running in about 58°c which is alright but I’m planning to add a small fan and some exhaust holes for the next version.