We have a GS108Ev3 and a Nighthawk X6 R8000.
GS108Ev3 has this famous 80-port 10Mbps issue, completely useless.
Today our X6 R8000 broke down. I factory reset it, then the 192.168.1.1 web page keeps redir to https://www.routerlogin.com/start.htm, which is 404. now it is a electricity wasting brick. hopeless crap.
I’ll fire any employee buys netgear again.
This post is an automated archive from a submission made on /r/HomeNetworking, powered by Fediverser software running on alien.top. Responses to this submission will not be seen by the original author until they claim ownership of their alien.top account. Please consider reaching out to them let them know about this post and help them migrate to Lemmy.
Lemmy users: you are still very much encouraged to participate in the discussion. There are still many other subscribers on !homenetworking@selfhosted.forum that can benefit from your contribution and join in the conversation.
Reddit users: you can also join the fediverse right away by getting by visiting https://portal.alien.top. If you are looking for a Reddit alternative made for and by an independent community, check out Fediverser.
😂🤣
I had the same issue with my ageing r8000p, just before I got rid if it. The firmware has been broken for that unit for years and they never bothered to fix it. Just pushed out a beta which I refuse to use especially on a Internet gateway.
I got around the dns failure by setting the IP on the laptop it was hardwired to.
IP 192.168.1.100 Subnet 255.255.255.0 Gateway 192.168.1.1
Dns1 8.8.8.8 Dns2 8.8.4.4
I then pushed the hardware reset button with a paperclip at the back of the router.
As soon as the led showed a lan wire connection, I punched 192.168.1.1 in a browser bypassed the wizard and selected manual setup this got me back into the GUI, I went straight to WAN setup and saved the dns settings (above) into the router.
For some reason, the factory reset blanked them out entirely. Then, it was just a case of entering the isp username and pass (which I didn’t bother with as after a firmware downgrade then upgrade I decided… I, too, was done with netgear)
I bought an Asus gt-axe16000 to replace it with. The only netgear thing I own now is an unmanged network switch lol.
Best of luck. I hope you get it sorted
I found my R8000 to be very reliable for eight-plus years. Although I’ve replaced it with an OPNsense router so I can have VLAN and multiple WAN support, I still roll it out once a year to support my Twinkly holiday lights. Sorry yours had an issue.
Netgear dumb commercial switches are good.
That’s where it begins and ends with them. Their Soho is shit. Has been for the last decade.
Last Soho I bought of theirs, a simple reboot would drop the configs 80% of the time.
The router after that was a tp link, it was good enough, def a step up from Netgear, but not great.
I ended up going mikrotik. Super solid, always updated, but man is it intense to learn. Would never recommend for a newbie to networking.
