The bigger the better, and the parts just keep getting bigger. 10” major diameter, 4350 heat-treat, ~40Rc. This bitch is tough, but that’s that shit I like. Blurry 6” scale for reference on my tool post.
Sounds like a lot of whittling to be done haha. Brake any tools yet, some hardend steel is quite the stubborn mule.
From Newcomers to Old Timers, a community united by the Industry of Machining
Rules Don’t post illegal stuff
Don’t post Porn (no sexy aluminum surface finishes don’t count)
Don’t be an asshat (harassment, bullying etc.)
If you’re going to post NSFW stuff, flag it as NSFW, It’s ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW
and Finally make sure to have a good time :D
155
Monthly active users
150
Posts
508
Comments
