Table saw to get straight sides. Belt sander to get a curve to the blade tip.
The spine doesn’t have a curve like a traditional bokken, but that doesn’t keep me from tucking this bad boy into my belt loop and walking around the house like a samurai :)
walking around the house like a samurai
As everyone ought to do. I approve!
!stick@sh.itjust.works may appreciate this
Pretty sweet, just be aware that if you whack it against hard things, dowels will sometimes break and splinter. Wear protective gear, just in case.
It shouldn’t, as long as the grain was straight and tight, but I have seen it happen a few times over the years with dowels being used. They’ll do fine as hanbo, but when you start whittling them down, you find any weaknesses pretty quick when you make contact.
But it’s way cheaper as long as you’re using it for poo and giggles, or with straight sword techniques.
Oak does okay, imo, but some folks swear it’s too prone to splintering with extended use unless the grain is super tight. I’ve never had problems with oak myself, the last boken I bought was oak and I wore it the hell out before I gave it away. And that’s what I’ve always used as a hanbo, an oak dowel. Never have broken personally, but I’ve seen it happen.
These are good tips and I appreciate it! I don’t plan on hitting anything or sparring with it, but I’ll be cautious when fighting off the shinobi in my back yard ;)
Paper Phenolic makes an excellent bokken material. I have a set. Hanbo and bo are also amazing.
