Avatar

LowQualityGoods

LowQualityGoods@lemmy.world
Joined
2 posts • 25 comments
Direct message

I could be wrong, but fairly sure it’s https://www.instagram.com/arsonprincess/ otherwise, here is the original video: https://www.youtube.com/watch?v=OAhgGWgUvBc

permalink
report
parent
reply

That was fun and only slightly went over my head

permalink
report
reply

Thanks, I was worried about trying this, but if it’s my only option I’ll give it a go after I try another clean and resolder.

permalink
report
parent
reply

Thanks, I’ll try and find the trace and solder a wire and maybe some supports.

permalink
report
parent
reply

Thanks,

awesome, I was struggling to figure out where tracers went, I’ll try the light trick.

I did try using flux, I tried cleaning it with a toothbrush dipped in isopropyl alcohol, but I’ll try water and bud tomorrow.

I think I’m using decent solder, I bought it from my local electronics store. It has no discernible branding but does contain a mixture which includes flux. My soldering iron is a fairly expensive one and has treated me well, but I don’t think I take good care of the tip.

I’ll try a sand as well tomorrow. Thanks for all the advice and encouragement :D

permalink
report
parent
reply

I’m excited, I’ve been replaying through the series. I’ll probably not pick it up immediately, but eventually.

permalink
report
reply

Ik, my brother was playing it by himself all last night. Jokes aside I’m really glad, I’m gonna round up the crew and mvm

permalink
report
reply

I think stick to the red if you’re mounting it near the existing one. Regardless, if you do end up printing the other colours, please post. I think an opaque green would look really good.

permalink
report
parent
reply