There’s no nuance here. Sex with a pre-pubescent child is, by definition, pedophilia. No matter what time it takes place in.

I should add that I’m using rafts and lifting the prints 5mm.

The preview does not have a ridge, nor was there one when I was supporting and slicing.

It may be because I paused the print to check raft adhesion. I’ll try some prints tomorrow without pausing.

It’s not supposed to be there, there was no ridge when I was supporting and slicing.

That’s what I’m beginning to suspect, other prints that have had ridges or offsets I paused as well.

I generally have my lift set to 7mm, which should be enough. If it continues even if I don’t pause the print, I’ll give it a try.

I don’t think it’s the render, there’s no ridge on the model when I’m supporting or slicing.

I updated to the newest firmware before I started printing (I’ve only had it for a month or so).

I’ll try without the pause, and then look into the z axis of that doesn’t solve the problem.

I’ve paused all the prints I’ve done (I’ve only had the printer for about a month), I’m hoping that’s the issue. If not I’ll definitely look into the z axis screw.