I’m with you 100% if push comes to shove I’m selling everything else before selling my tools. Unfortunately. My tools are where a lot of my money is lol.
Unfortunately that has the same issue as well. These triangles are due to the 3 closest perimeter lines meeting, thus concentric ends up with the same issue.
They dramatically increase print times and increase blemishes. It’s such a small surface area, that it just ends up creating blobs and shakes the printer.
I’m with you 100% if push comes to shove I’m selling everything else before selling my tools. Unfortunately. My tools are where a lot of my money is lol.
I probably should adjust the acceleration settings. In this instance, Im just trying to optimize the print to cut down on print time. There’s about 15 or so of these needlessly small sections per layer, so culling them would cut down the print time a bit.