algorithmae

I gotcha. Sounds like as long as you connect USB only when the printer is powered on then you shouldn’t have issues

I’ve never heard of that issue before. I have a 2020 year Ender 3 and we have a half dozen at work also around the same age and have run all of them through USB with no problem

Look at the other posts in this community, we’re on the dancing cookie arc

Yeah right, only idiots get banned there.

(USER WAS BANNED FOR THIS POST)

I test drive a regular Audi A4 and Infiniti Q50 a few times and became hooked on owning an AWD. It doesn’t snow where I live but the handling was everything I ever wanted. Currently searching for an AWD version of the car I want next and there’s like none down here, it’s super frustrating

Legitimately the best answer here. OP sounds like they have tendencies that aren’t good for long term social and mental health.

Ignore all the stuff that says Klipper. Install the program called pronterface and then hook up your printer to your computer with USB. You can then run the commands the guide tells you.

You should really figure out how to calibrate the esteps if you never have before, it’ll save you a headache. This tutorial is a good visual: https://youtu.be/6PL_rSPZ3M8

Okay, but you have to realize that they’re under no obligation to please you.

Even if the opportunity presented itself, it’s not necessarily the case that it would have come to fruition. Chances are that person wouldn’t have bothered to make a video even with your request, because they were likely panicking about their stuck ring. I’d be happy that my advice helped the person out without pushing my luck to get a video out of it too.

Another bland electrified crossover. Yawn.