This is the right answer. You’re hot end is pulling tight and causing this skew.

Air Gradient. I bought their DIY kit.

Cheers, Henry.

Twitter just locked down, need an account to even view now. Reddit is filled with bots spamming posts from 5 years ago. People are flocking to wall-gardens like discord.

Might be the decline of the internet 🤷

3000hrs straight usage? That’s impressive.

Hard Drivin’?

I want one of the stick shift arcade machines so bad.

Well, duh. That just means that 93-84% of Redditors are bots. Bots didn’t know there was a shutdown, so those bots kept slamming reddit. So with that data I now can assume Reddit was only 7-16% human.

Hey thanks. I was looking at the makerbase boards, good pricing and features!

Cheers Henry

Yeah the issue is AnyCubic seems to have dropped support for this board and any configs online are done by the community. But all of them are guessing the config because AnyCubic didn’t release any code or examples. Very annoying.

I think sometimes you need to either cut or tape the 5v pin on the usb cable. The ender 3s send out 5v instead of accepting. I had to do this on both my ender 3s.

Cheers Henry