neal33
I had a similar issue when I initially installed Klipper on my Ender 3 S1 (not the plus). It would not connect unless I fully restarted Octoprint whenever I turned on the printer. The change I needed to make was go into settings in Octoprint (though I assume its similar on other front ends), and add the following settings:
Serial Port: /tmp/printer
Baud Rate: 11520
If that is not the case for you, try to add some more details. Do you have the config file correct?
Just curious, when making this how much tolerance did you account for? I want to make some for baseball teams, but wasn’t sure how much to add.
Something is blowing in. It’s very windy here. Only gets like this before a storm.
What type of material are you printing? Could be the material is eating away at the brass nozzle causing you to need to adjust the z offset.
Similar results with my Ender 3 S1. Highly recommend!