Has there been any progress on getting network connectivity for the Saturn 2? Coming from using Octoprint with my FDM printers, the Saturn 2 feels like a huge downgrade.
Options:
- Octoprint-Chituboard - Doesn’t work for Saturn 2 due to CTBv4 file format
- Alternative firmware - I am really hopeful for the .goo file format but haven’t seen any news that it will be coming to the Saturn 2. The board runs on an STM32 microcontroller (stm32f407zet6) which can be reflashed. Again, a great open source opportunity for someone smarter than me.
- Alternative controller board - If we can’t find an improved firmware, a whole new board wouldn’t be impossible. I haven’t found anything available but we’re only driving a stepper motor, displaying images and controlling the UV light. This should be an easy win for an open hardware design.
- Upgrade controller board - The Saturn 3 Ultra added much better connectivity but sadly locked that down to Chitubox slicer.
You are viewing a single thread.
View all comments 
2 points
Hm, interesting that the board has a solder point for an ethernet jack, but I see none of the usual “support” components near it that are typically also required (a PHY and/or network chip). Could be that that’s supposed to be run in software on the MCU, but that would require that the firmware supports/includes it.
1 point
