After tuning my vref, the printer was missing steps still. I pulled the trigger and am swapping from the 4.2.2 to the 4.2.7 creality board to see if that resolves the issue.
While i was in there, I figured I’d put another z axis motor on there.
Do you guys have any recommendations on firmware or should I just stick with creality’s?
You are viewing a single thread.
View all comments 4 points
If you’re sticking with Marlin, I’ve been very happy with the “professional” firmware. The configurator is pretty easy to set up if you change any hardware like a new bltouch or new hotend if that’s your thing.
2 points
