Do I have to sand or is there some magic I’m not aware of?
They are indeed support marks. I’ve already messed with orientation and this is the position with the least marks so far. I haven’t really messed with support settings yet. Thanks for the idea.
As a consummate resin printer, a couple points: those support blemishes are a result of penetration depth and can be rectified by dialing that setting back while offsetting its load with additional, smaller supports. Furthermore, the photo indicates your object’s angle during printing is not the correct arctan, and I highly suggest you look into calibrating that accordingly. Lastly, and this is not to be shrugged off lightly: assuming the object is a prototype piercing adornment, please do your due diligence and research the physiological dangers of prolonged skin contact with not only MSLA resin but any/all varnishes, etc. you use in post-processing, as well. This is no joke; they can often be incredibly damaging with irreparable life-long effects.
Thanks!
Everything I found said that cured resin is inert. I did see that there are biocompatible resins out there but they seem to be mostly used in dental applications. I’ll keep searching though.
IIRC, cured resin is not as toxic as uncured, but it is in no way “inert”. Piercing locations are typically soft tissue, and therefore more susceptible to contact issues. Please, be safe, and if you’re selling these: ensure your clients are, too. To put this in perspective: would you feel as confident in this “inert” state were you printing binkies for infants?
Here is an alternative Piped link(s): https://piped.video/watch?v=-pbi6CkZxgA
Piped is a privacy-respecting open-source alternative frontend to YouTube.
I’m open-source, check me out at GitHub.