Why are 3D printers still stuck on stepper motors? Why haven’t we transitioned to servo motors with encoder feedback for positioning?
Is it just too cost prohibitive for the consumer-level? We would be able to print a lot faster and more accurately if we had position feedback on the axes. Instead we just rely blindly on the stepper not skipping any steps when we tell it to move, hoping for the best.
Have you seen how fast printers with stepper motors can get? They print benchies in less than 3 minutes. The bottleneck is not the motion system, it’s either the hot-end or the part cooling. Also stepper are super accurate and very flexible. Drivers are advanced and can tune for torque, speed, sound etc. Collision detection and skipped step detection is also a thing.
Not disputing, I want that 3 minute benchy. Where does one find this magic?
Here is an alternative Piped link(s):
https://piped.video/IRUQBTPgon4
Piped is a privacy-respecting open-source alternative frontend to YouTube.
I’m open-source; check me out at GitHub.
3 minute benchy
It’s custom made printers and it makes shitty prints.
https://www.youtube.com/watch?v=IRUQBTPgon4
