Hey there 👋
I’m looking for filament recommendations (preferably PLA) which glows in the dark, specifically, the ones which glow the brightest/the longest.
I.e. the GITD filament with the most particles (I think)?
Any recommendations?
cnckitchen did a pretty good comparison of different gitd filaments. There’s a video on their channel too.
I don’t remember if the comparison covered this, but I would expect PETg to work better than PLA for gitd stuff because it’s inherently more transparent, right?
I should have 3 different glow filaments somewhere, one PETG, two PLA. Typically I preferred the PLA versions - they had a bit more uniform glow. The PETG one had brighter spots, but as it was mostly transparent individual spots were more visible than with the PLA prints.
Nothing glow-in-the-dark is anything that could be described as “bright.” What you probably want is something that is florescent under a blacklight. Someone probably makes something specifically for that, but otherwise, a lot of dyes are naturally florescent
Not hatchbox, that’s for sure.
If it’s colored, it’s bad. I have a lovely purple GITD pla that even had a warning about the purple one not being that much glowy, it still surprised me. Very short time, very dim even if charged with a UV light… I like the color so all in all no big deal, but wow. Speaking of the suggestion of using UV reactive filament (light that, by the way, would keep the GITD ones glowing) some colors just look bright even without needing to be special. For example I have a bright green PETG that pops with UV light.
FYI I’m now using eSun GITD but the non-rainbow variant; just the regular green one.
Orange, and especially blue, have basically no glow to them whatsoever, so don’t use those.
This is the one I’m now using: https://esun3dstore.com/products/esun-luminous-pla-1-75mm-3d-filament-1kg?variant=42987305926871
It’s pretty good, an performs a lot better than any of the rainbow ones, and better than the green one from ERYONE
