Avatar

Impossible

Impossible@partizle.com
Joined
2 posts • 22 comments
Direct message

Hoping that this leads to a standard which benefits all parties. USB type standard for electric cars equalling a standard nozzle type for combustion cars.

permalink
report
reply

Personal data is the new ‘oil’

permalink
report
parent
reply

A Thunderbolt cable will handle the required bandwidth from the dock to the laptop.

Your phone, do you expect to pass data via the phone and your laptop (eg photos/videos?) If you do then a USB 3.2 10 Gbps cable would be the most you would need (€25), costs may stear you towards a simple charging cable something around 60w (€10) would be ample BUT you phone may not fast charge due to Samsung’s charging preference.

HDMI 2.1 would be ample for a your monitor (4k resolution at 120fps) and the cost difference between this (€13) and 2.0 (€10) is minimal nowerdays

Ethernet is easy, CAT5e in the colour/length of your choice would supply the potential max 2.5gb Ethernet port you have (€8 for 10meters). Higher the CAT rating the more costly the cable.

Additional Thunderbolt ports would be best used/reserved for high-speed external storage or even a gaming GPU.

The fact your asking about these items shows you should be pretty much covered for the next few years of ‘fitire proofing’

permalink
report
reply

I wouldn’t worry about the value difference too much but more the consistency. If you need 75 degrees on the edge then keep dialing up the temp until you get it.

It’s most likely only going to affect large prints at the end of the day.

Your printer will measure the bed from a single location so moving your IR sensor will vary across the bed. If your using a custom firmware I’m sure you could set this as an offset assuming your IR thermometer is accurate ;)

Heat of the bed will be the warmest point and the periphery cooler (just like your body temp)

permalink
report
reply

It’s a great question. I am missing certain content from the niche sub-reddits and trying hard not to fall back to Reddit.

Some of this ‘reposting’ will help the community to add comments/interaction but as you mention may turn this platform into a leech.

Either way people implementing Bots helps the moderation teams to some extent.

permalink
report
reply

It was a World Rallycross Championship (WRC) event/car.

No relation for a Formula E or Formula 1 car.

permalink
report
reply

I’ve seen these items around and never considered them and proceeded to buy a USB C dock instead. Your comment about a ‘single’ item to pack hits home well and considering one for my TV setup.

What length of USB C cable do you use from your charger to your Deck? I’m thinking I may need to be around 3 meters away.

permalink
report
reply

Running DVB-S2 for many years and SAT>IP (think of it as Satellite decoding to rstp) seems to be the way. I’ve not thought about a smaller PC to host my current card and welcome your suggestion. I’d github’d minisatip a few weeks ago and the penny didn’t drop!

I had planned to go for an Enigma2 based device and go from there.

permalink
report
parent
reply

What’s the bigger opinion on this. Is MS pushing onPrem Exchange as rotten apple to encourage the shift to 365 or are they genuinely pushing this info out for Administration awareness?

I would assume at this point any Orgs using onPrem are needing the services and thus assume it’s for awareness?

permalink
report
reply

DSP is a game I would love in the Deck. I can imagine it would be difficult to manipulate. I thought about trying to use the Gyro to aid movement in some way but never tried.

I did spend around 4 hours overall on Shapez


https://shapez.io/

Local saves only from the non Steam version though.

permalink
report
reply