DancingPickle
- Mastodon: @jq@vmst.io
- Matrix: @jq:envs.net
for me, reddit nearly always has way more quality content and news for me though for the time being
It’s not just you.
As constructively as I can put this, reddit has been building community and goodwill for many years. Lemmy has only recently become an option and it’s done wonderfully in the short time it’s had.
The challenge is the catch 22. People go where there is more content, they produce content there, and then there is more content there. There no vacuum, reddit didn’t disappear. It became toxic and people apparently care less about avoiding toxicity than filling up on dank memes.
All I can say to that is we all need to be the change we want to see in the world. Adopt a Lemmy First mentality, and go to reddit only to pick up legacy slack. Continue the conversation from there over here. Link it up.
Look forward to talking to you!
I would not be surprised to learn that you could make as much profit open sourcing the work and using Patreon instead of demanding users pay to release the shackles.
Do it your way. I will probably pay you when you come out with a widget. But I would have done that anyway. Shoving ads in my face makes me not like you.
Did this community just whiff /r/selfawarewolves
Not so much a move as an addition. And there are a few reasons.
One, I like projects where the outcome is a useful tool, but the project aspect itself is a significant part of my motivation.
The reason for the Voron being that project is that it will be a WAY faster and more competent tool than my ender, which was a prohibitive limitation especially for larger prints. A failure at hour 23 of a 24 hour print sucks, but the same print failing at hour 3:45 of 4 hours is way easier to accept. At that point the loss of filament matters more than the lost time in my eyes.
Also Voron2 has a much better design than ender 3 pro for exotic filaments, making ABS / ASA / nylon more approachable. Better tuning options, compensation (lower / less moving mass), bigger plate, taller build volume.
The bigger plate is significant for things like ergo mechanical keyboard chassis. I’m a Dactyl Manuform user and builder, and the ender 3 pro can only print one half at a time and takes more than a full day each half. Voron should be able to knock out two halves at once inside of a work day, and do so with better quality to boot.
The ender still has a place, particularly with the mods I have on it. Specifically, TPU can’t benefit from the speed of Voron, so there’s no reason not to print it on ender. Also it never hurts to have a tuned, working machine if you have to take one offline for maintenance.